Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might discover that your garage door opener has actually been giving you problems, so you require to fix it. You can fix it by replacing a circuit card, a photo-eye sensing unit, the main drive gear, or the set-limit switches. You can also examine if the safety sensors are working properly.

Replacing a circuit card

Replacing a circuit card for your garage door opener requires a few actions as well as devices. Initially, you need to turn off the breaker and also detach any type of cords. Next off, open the motherboard cover. This will certainly assist you to identify the issue and determine if you require a new board. Next off, get rid of the old board and its cord ports.

You can after that continue to change the motherboard. The replacement procedure is easy and also takes around 10 mins. A new motherboard will certainly cost concerning $80. To protect your new circuit card from power surges, you can buy a surge protector.

Changing a photo-eye sensor

Replacing a photo-eye sensing unit can be a relatively easy task. First, get rid of the sensing unit from the door and ensure it is positioned appropriately. If the sensing unit is angled whatsoever, it might not be obtaining the appropriate signal, which might be causing the blinking lights. If you discover that the photo-eyes run out alignment, you may require to have a technician come and also fix the problem.

The photo-eye sensor consists of two items that mount on the outside of the door tracks as well as towards the floor. The image eyes will certainly have a little LED light as well as ought to be strong in color. If the light is blinking, its most likely the photo-eye is malfunctioning and also will certainly require to be changed.

Changing a main drive equipment

To change a garage door opener major drive gear, beginning by eliminating the cap from the chain wheel. Next off, get rid of the two screws holding the drive equipment to the gear setting up. Now, you can loosen the three tension pins. Press them from both sides and then eliminate them. Then, separate the 3 wires from the garage door opener electric motor. These wires must be white, red, as well as blue.

Once you have actually eliminated the old equipment, install a brand-new one. Make certain to oil it well. Place the new equipment right into the shaft, making certain to align the mounting holes. Make certain the equipment and gear setting up are located properly to make sure smooth operation. Next off, make use of a hammer and a nail to drive a pin into the new gear.

Changing the set-limit buttons

The initial thing you need to do if your garage door is not functioning correctly is to inspect the set-limit switches. You may require to adjust them to make sure that the door shuts earlier or quits before it reaches the flooring. You can inspect this by checking out your garage doors handbook or online.

To adjust the set-limit switches, youll require a screwdriver or outlet. Adjust the knob clockwise or counterclockwise until the door goes up as well as stops, or minimizes its range. To look for correct traveling range, measure the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top